Forum Discussion
Windows 11 23h2 update or in place upgrade to 24h2 or 25h2 fails on reboot
For quite some time, I was trying to upgrade my home computer to 24h2, and it would always fail on reboot after reaching 100%. I received the standard stop code that points to a bad driver. Boot fail...
I've been trying to leave replies for three days, now.
The RAID isn't set up in the motherboard BIOS, as it was built using the two SSD7505s, not the built-in AMD RAID solution. The SATA ports are already set to AHCI mode. I look forward to any additional troubleshooting steps I can take. I'm worried that if I get the update to work without the 7505s, I'll be stuck being unable to use them at all, since I'm pretty sure the extant problem would resurface and prevent booting again, if they're the ultimate culprit. Thanks to everyone who has contributed thus far!