Windows 10 stuck on automatic repair loop and never boot into desktop

If your Windows 10 is stuck on automatic repair loop and never boots into the desktop, performing a CMOS/EC reset can sometimes resolve the issue. Resetting the CMOS (Complementary Metal-Oxide-Semiconductor) or embedded controller (EC) resets the BIOS settings to their default state, which can fix hardware or configuration issues causing the boot problem.

How to fix Windows 10 Stuck on Automatic Repair Loop

1. Understanding CMOS/EC Reset

• The CMOS is a small memory chip that stores BIOS settings.
• Resetting it clears all custom BIOS configurations, including boot order, overclocking settings, and hardware configurations.
• Resetting the embedded controller (EC) can also resolve hardware communication issues that might prevent Windows from booting properly.

2. When to Use CMOS/EC Reset

• If you've recently changed BIOS settings, hardware, or firmware.
• If your system is experiencing hardware conflicts or boot issues like Windows 10 stuck on automatic repair.
• If other software troubleshooting steps haven't worked.

3. How to Reset CMOS/EC

• Turn off your PC and unplug it from power.
• Open the computer case (refer to your PC or motherboard manual).
• Locate the CMOS jumper (usually near the CMOS battery) — often labeled CLR_CMOS, CLEAR, JBAT1, or similar.
• Move the jumper from the default position to the reset position (consult your motherboard manual for exact instructions).
• Wait for 10-15 seconds, then move the jumper back to the original position.
• Close the case, plug in your PC, and turn it on.

4. Check BIOS Settings After Reset

• Once reset, enter BIOS/UEFI setup during startup (usually by pressing Delete, F2, or Esc).
• Ensure the date and time are correct.
• Set the boot order to prioritize your primary drive.
• Save changes and exit.

5. Boot into Windows

• Restart your PC and see if it now boots normally, resolving the Windows 10 stuck on automatic repair issue.