Forum Discussion
ConfigMgr 2603 PXE suddenly stopped working
Since the client reaches the PXE-enabled distribution point but stalls before WinPE, I’d focus on the boot-file transfer before rebuilding WDS again. TFTP is a normal part of PXE, so the failed manual test is worth investigating, although it doesn’t by itself identify the fault.
Capture traffic during a failing boot on the DP and, if possible, from a mirrored switch port. Check the requested boot filename, server response, retransmissions and any TFTP error; compare those timestamps with SMSPXE and WDS logs. Verify the expected files and Boot.sdi are present under RemoteInstall, and check the relevant network paths and TFTP settings. An oversized TFTP block or window can cause timeouts, so test a smaller setting if the trace supports it.
Also record the client’s exact PXE error and firmware mode. Your separate DHCP server can still require the existing IP helper. Re-enable any security controls disabled for testing.