Cannot enter new credentials after fresh installation

Question

This is so funny, I just installed the latest version (16278) on a VM and it is not getting past the Enter credentials for Administrator prompt.

Basically it shows me stars as I type, but does not move the to the confirm password part when I hit enter.. not matter how hard I hit it :D

What's wrong?

walid almoselhy · Answer

Ok! So it works when I hit the down arrow but not Enter.&nbsp;Good job guys :)

brandon braindead · Answer

I was literally stuck for 30 minutes till I found this, seriously been doing this since DOS 3.1, that never crossed my mind :P Thanks

pforcedoffthepremesis · Answer

Thanks! This is the only thing that worked.

mohiminul · Answer

&nbsp; how can i solve this problemWalid AlMoselhy&nbsp;

berrayahkamel · Answer

Mohiminul&nbsp;&nbsp;&nbsp;don't use "Enter" to go to the second line , Just use&nbsp; Key DOWN to move to the second line and tape your password again&nbsp;

Forum Discussion

Cannot enter new credentials after fresh installation

5 Replies