Forum Discussion
User based forwarding detection
Setting it via OWA will be reflected, are you checking all the relevant properties? Here's a short article I wrote on this a while back: https://www.enowsoftware.com/solutions-engine/simplified-forwarding-settings-in-office-365
How exactly is forwarding enabled by the end user? If he enables it via OWA settings, it's visible via Get-Mailbox properties. If he enables it via rules, it's visible via Get-InboxRules. Any other methods dont count as "native" and are not covered by the management tools, not much you can do there.
VasilMichev it is via OWA, however when I look at their mailbox in powershell, I dont see anything...if I set it via ECP as an admin, then I see it
Setting it via OWA will be reflected, are you checking all the relevant properties? Here's a short article I wrote on this a while back: https://www.enowsoftware.com/solutions-engine/simplified-forwarding-settings-in-office-365
VasilMichev very nice write up! I just tested it again and its there...dont know what happen the last 2 times...thanks for this info!