Sensitivity Labels in Purview data map

Question

Hallo,&nbsp;I'm trying to use sensitivity labels in the purview data map. I've done the following:1. Registered my data sources2. Performed a full scan and configured daily incremental scans&nbsp;Assets were found and classified:After this, I edited two of my sensitivity labels to be available for Purview assets and configured auto-labeling for files and emails and schematized data assets. As conditions, I specified the sensitive information types, which have already been found in my assets.&nbsp;However, none of my assets has been labeled. I did this configuration change for my labels 10 days ago. The labels are published to "All users". I manually re-scanned all assets with a full scan.&nbsp;Any idea on why the label is not applied? All files all located in either Azure Files or Amazon S3 Bucket, which should be supported for labeling.

tgrenell · Answer

Is you O365 account supported for this? See https://learn.microsoft.com/en-us/azure/purview/how-to-automatically-label-your-content#step-1-licensing-requirements

mod-a830 · Answer

tgrenell&nbsp;Yes, I have E5 license, consent for labeling in data map has been granted two years ago and sensitivity labels are configured per requirement.

tgrenell · Answer

MOD-A830&nbsp;You must run a new scan, changes to labeling are not retroactively applied.&nbsp;

mod-a830 · Answer

I ran severall (full scans) since then. The problem seems to be solved since friday, when I onboarded a new source. Once, the new source was onboarded and scanned, all existing assets suddenly showed up with the right sensitivity label. Dont know what's the cause.

Forum Discussion

Sensitivity Labels in Purview data map

4 Replies

Resources