Forum Discussion
Retention Compliance Policy exemption group honoring
My thanks for your reply.
These were the powershell commands I was using to craft up the new policy and corresponding rule (sanitized):
# Sanitized
New-RetentionCompliancePolicy -Name "<policy name>" -Enabled $false -ExchangeLocation All -ExchangeLocationException "<mail enabled group identifier>" -Comment "<comment>"
New-RetentionComplianceRule -Name "<rule name>" -Policy "<corresponding policy name>" -RetentionDuration 2555 -RetentionComplianceAction Delete -ExpirationDateOption ModificationAgeInDays
There was a mail enabled group name filled into the command when I ran the completed policy command line.
I'm able to see the disabled policy in the Purview Policies subsection. But when I edit it and traverse through to the section on the policy details, the "excluded" column is blank
That's what makes this so confusing. It looks like it took the command, it looks like it took the mail-enabled group name for the Exception. But the GUI shows that the group isn't there
The Get-RetentionCompliancePolicy powershell command also shows that the exception group hasn't been set:
Any thoughts?
The group itself will not be reflected, neither in the UI nor via PowerShell. Its members will, so the question here is was the membership populated at the time you configured the policy? Keep in mind that this is a one time operation, the current membership of the group will be stamped under ExchangeLocationException and no future changes will be reflected.