Forum Discussion
Powershell as telnet client.
Hi @, i'm using PowerShell as a telnet client to connect to a Cisco device. When I perform some commands, PowerShell cuts off the output, so I don't see the whole thing. please help.
It's not a server. A Cisco router, but I am using a 3rd partie simulator to access it.
CharafGue did you try the module I posted on my comments above? (using SSH)
CharafGue Nice, good to hear!
Please click Mark as Best Response & Like if my post helped you to solve your issue.
This will help others to find the correct solution easily. It also closes the item.
If one of the posts was helpful in other ways, please consider giving it a Like.- I've got it! My local server, which runs routers and switches, is a mess, and I need to configure ssh and IP addresses...
Thank you.