Unable to supply static IP during cutover using storage migration service

I am on the third phase of the Storage Migration Service.  The second step is to configure the cutover from server A(source) to server B(destination).  The network settings of server A are correctly identified.  The network settings of server B are correctly identified.  I have the option to use DHCP or supply a new IP address of the source server after the cutover.

If I choose DHCP the "Next" button at the bottom of the page becomes active and I can continue.

**If I choose instead to supply static IP address information the "Next" button at the bottom of the page will not become active and I am stuck not being able to continue.**  I tried typing in the Source IP address, no luck.  I tried typing in the destination address, no luck, (was hoping it would throw an error.)   I have tried using three other different addresses, no luck.  No errors, just the "Next" key will not become active allowing me to move forward.

Is there a problem in the wizard?

Thanks,

Mark