Forum Discussion
MDI Sensor service wont start on AD FS server
I've installed the MDI sensor on one of my AD FS server according to the guide but the service will not start.
According to the logs it through the following exception:
2021-01-11 11:11:5...
bjarneabraham
go to the sensor list in MDI portal, click on this new sensor name, and add to the list in the dialog a fully qualified DC name that it can use to resolve AD entities.once that it should start fine within a few minutes.
EliOfek
Microsoft
Microsoftbjarneabraham
go to the sensor list in MDI portal, click on this new sensor name, and add to the list in the dialog a fully qualified DC name that it can use to resolve AD entities.
once that it should start fine within a few minutes.
EliOfek I'll check and try later and get back, thanks.
- It worked 🙂
I was not able to see this in the install guide?
At the moment I've added two DC's to the list - it do now have a health issue towards one of them which seems strange as the sensor logs indicate that it's communicating with both DCs in the list?- Everything is good now 🙂 Just had to wait a bit...
