Hyper-V Core - Setting up a VLAN

Hi Kidd_Ip

Thanks for the detailed response.

It seems I don't understand this community platform very well. I've responded twice but when I come back to this forum entry my responses are not showing.

A few points that need further understanding.

a) If I manage to get this VLAN setup (of which I have not managed so far) can you advise if I can still manage the VMs via Hyper-V manager remotely. At the moment I am assuming this will not be possible because the 5 VMs will be on there own isolated network. This is the reason why I was thinking I will have to change from Hyper-V core to a proper OS install thinking that if the Hyper-V is hosted on that I can then at least access the Hyper-V guests via the GUI based Hyper-V host.

The main reason for my attempts being unsuccessful so far is because is I follow the instructions above then look at the remote Hyper-v manager I see that the guests are set to "VLANSwtich" but No VLAN ID is set. Has this anything to do with me trying to setup 5 checkpoints of 5 VMs as opposed to setting up 5 VMs without checkpoints?

b) As I'm not that experienced in network setups I need a little more understanding on how to setup Hyper-V using a Trunk port. Can you advise a good reference on how to do that?

c) Lastly again as I'm not that experienced in network setups I need a little more on how to setup the NAT to route traffic from VLAN 100 to the internet.

Thanks in advance,

Regards,

Barry