I am unable to run get-ADPermission when exchange 2016 is invoked

[Harshaacharya08]

I tried many ways, but "get-ADpermission doesn't work" it says un recognized. However wen i try with installing (add-snapin Microsoft.exchange ...) it throws error. I am unable to perform any 2016 related task.

[#2]

Hi @Harshaacharya08,

Could you send a screenshot of the error you get when you type the command "Add-PSSnapinMicrosoft.Exchange.Management.PowerShell.SnapIn"?

[#3]

Please find the attachment

[#4]

@Harshaacharya08 

Hi, 

There is no Attachment

Did you try to start a PSRemote session which should be working fine with you

https://www.alitajran.com/load-exchange-management-shell-in-powershell-ise/

$Session = New-PSSession -ConfigurationName Microsoft.Exchange -ConnectionUri http://YourServer.FQDN/PowerShell/ -Credential $UserCredential

[#5]

Hi @Harshaacharya08,

There is no attachment. 

[#6]

Attachment

[#7]

I tried this, but wen I call the session I don't get the get-adpermission,for 2010 session I get the option but for 2016 I don't, that's the reason I tried installing the addsnappin, I get the below error

[#8]

Hi @Harshaacharya08,

Can you run the Get-ADPermission command as follows?

On a server with Exchange 2016 installed

1. Run PowerShell as an administrator.
2. Run the command "Add-PSSnapinMicrosoft.Exchange.Management.PowerShell.SnapIn".
3. Run the Get-ADPermission command.

[#9]

@Harshaacharya08 

Run the following command 

Get-PSSnapin -Registered

are you able to see your exchange snapin, if not then I think it's better to reinstall it (I assume this is a management client PC).

Do you have both management module for both Exchange 2010 and 2016 installed on the same PC ( as I understand ) or not.

[#10]

Hi, Did any solution work for you?!